|
|
(click
for popup photos) |
- 21" (533.4mm) wide
- 46" (1168.4mm) long and
- 36" high (914.4mm ) - collapsed for horizontal storage (length extends to 80" in this configuration) or
- 82" (2082.8mm) high - collapsed for vertical storage
- 93" (2362.2mm) high - extended for classroom use or
- 108" (2743.2mm) high -extended for outdoor use
- 210 pounds (93.7kg)
- Kyocera 35 watt, 2.33 amp, 15 volt aluminum framed cell
- Self-regulating, 25 year warranty
- Dimensions 25.7" X 18.5"
- Cell is mounted with predrilled holes for angles 30, 35 & 40
- For more information see www.kyocerasolar.com
- Air X wind generator
- Rotor diameter 46", weight 13 pounds
- Startup speed 7 mph, voltage 12 volts
DC
- Rated output 400 watts at 28 mph
- Self regulating
- For safety reasons we have added a stop switch on the exterior
of the Green Energy Machine housing
- The teacher or instructor engages the wind generator with the stop switch
- Unprecedented 3 year warranty
- For more information see www.windenergy.com
- Vanner 500 watt inverter/ battery charger
- Peak power output 500 watts
- Output power surge 700 watts
- Output power continuous - more than 400 watts
- Output wave form - modified sine wave
- Efficiency 90%
- Number of AC outlets - 2
- For more information see www.vanner.com.
- Can be stored in horizontal or vertical position
- 12 volts DC, 55amp hour
- Sealed lead acid rechargeable battery
- 1 voltmeter for system voltage
- Separate amp meters for PV cell and wind turbine
- Assembled Components
Ground is supplied either by: plugging in the inverter/charger
and using the grid or by an exterior ground bolt located on the left side
of the Green Energy Machine (grounding cable not included).
Four wheel dolly is a 600 lb. capacity Milwaukee with pneumatic rear tires and
lockable front tires.
All components, brakes and safety features
are labeled.
We have added expandable outriggers to the
under-structure to aid in stability when the wind turbine pole is
extended for operation.
The Green Energy Machine has been designed to be a renewable energy educational display.
Although it is fully functional, it is not meant to be kept outside or get wet.
The right side of the wind generator main body is cut away so that the inside components can be seen
(stator, brushes, etc.).
The case that houses the Green Energy Machine is
constructed of plywood, plastic laminate,
melamine, and LEXAN sliding (lockable) doors. Edges are protected with
vinyl bumper guards. The back side of the unit has an access panel for any
maintenance if needed.
The wind generator is electrically connected
to the battery with a quick disconnect
retractable cord.
The disconnect is at the wind generator head.
|